冲压上下料机械手作业时要注意什么?
时间:2018-02-05 来源:本文搜集于网络,由冲压上下料机械手厂家创盈时代整理并发布,欢迎转载。 点击:1055
一、检查冲压上下料机械手各部分的润滑情况,并使各润滑电得到充分的润滑;检查模具安装是否正确可靠;检查压缩空气压力是否在规定的范围内;送料机务必要使飞轮和离合器脱开后,才能开启电机;电机开动时,应检查飞轮旋转方向是否与回转标志相同;使压力机进行几次空行程,检查制动器,离合器及操纵部分的工作情况。
A check, punching, lubrication condition of each part of the manipulator, and the lubricating power get sufficient lubrication; check mold installation is correct and reliable; check whether the pressure of compressed air within the prescribed limits; feeding maintenance necessary to make the flywheel and clutch, to open the motor when the motor is actuated, should check; flywheel rotation direction is the same flag and rotary press several times; the air travel, check the brake and clutch control part of the work.
二、应定时用手动润滑油泵向润滑点压送润滑油;压力送料机机性能未熟悉时,不得擅自调整压力机;绝对禁止同时冲裁两层板料;发现上下料机械手工作不正常应立即停止工作,并及时检查。
Two, we should regularly use manual lubricating oil pump lubrication points to pressure lubricating oil; feeding machine performance is not familiar with the pressure, will be allowed to adjust the absolute prohibition of blanking press; and two layers of material; found stamping manipulator is not working properly should immediately stop work, and timely check.
三、使飞轮和离合器脱开,切断电源,放出剩余空气;将压力送料机擦拭干净,工作台面涂防锈油;每次运行或维护之后做好记录。
Three, disconnect the flywheel and the clutch, cut off the power, release the remaining air, wipe the pressure feeder, and coat the rust proof oil on the work surface, record every operation or maintenance.
深圳市创盈时代科技有限公司是一家专注于冲床机械手,上下料机械手,冲压机械手,工业机器人,非标自动化设备的研发生产和销售于一体的国家高新技术厂家。
原文地址:http://www.chytime-robot.com/jszc/424.html
本文关键词:冲压上下料机械手